Filter
Top Products
ASSEMBLY
EK II 03/09 Assembly Section 4-3
©2009 Alamo Group Inc.
ASSEMBLY
The tools you will need at the assembly site are as follows:
1. Impact wrench or socket and ratchet set.
2. Rubber mallet.
3. Box-end, Allen, and adjustable wrenches.
4. Alignment pins.
5. Forklift or hydraulic floor jacks with rolling back boards.
6. Small chain hoist or block-and-tackle.
7. Multidirectional Levels.
8. Hydraulic Filter Buggy or Cart.
9. Safety shoes, safety glasses, and gloves. A hard hat should be worn by anyone working under any
raised component.
Remember to follow each step closely and cautiously. Be aware of all support personnel at all times.
Keep the assembly area as clean as possible; clean up all spills when they occur. An uncluttered
assembly area and a crew that is sensitive to the hazards involved in putting this implement together will
help prevent accidents. Keep all unauthorized personnel from the area. Do not allow children near the
assembly site nor allow them on or near the tractor after assembly. There is no safe place for anyone
except the operator on the tractor and those assisting with the assembly.
RECOMMENDED TORQUE VALUE CHART