Filter
Top Products
ASSEMBLY
EK II 03/09 Assembly Section 4-2
©2009 Alamo Group Inc.
ASSEMBLY
GENERAL ASSEMBLY
To help you assemble your new DB150 and mount it to your tractor, we provide you with drawings,
instructions and general information. When needed, you can get information or clarification from Rhino
Customer Service.
This publication provides general information not specifically for your case or tractor, but, in connection
with the drawings. This publication offers you some valuable assistance - please read it thoroughly.
These instructions have been prepared to assist you in the correct procedure for mounting a DB150 on
your tractor.
Throughout these instructions, references are made to right or left directions. Right and left are
determined by sitting on the tractor seat and facing the direction of travel.
This is the Safety-Alert symbol. When you see this symbol on your machine or in these
instructions, be alert to the potential for personal injury.
Follow recommended precautions and safe operating practices.
Indicates an imminently hazardous situation that, if not avoided, WILL result in DEATH
OR VERY SERIOUS INJURY.
Indicates an imminently hazardous situation that, if not avoided, COULD result in
DEATH OR SERIOUS INJURY.
Indicates an imminently hazardous situation that, if not avoided, MAY result in MINOR
INJURY.
NOTE: This mower unit's hydraulic components have been carefully cleaned and packaged at the factory
to prevent contamination from entering the system. However, dust and dirt particles may enter into the
sealed components through transportation, handling, rain or just sitting in a dirty or harsh environment.
Therefore to assure that the hydraulic system is properly clean please adhere to the following procedure.
Prepare the area where the unit is to be assembled. The area should be on a hard concrete floor that has
been swept clean of all dust and contaminants. Un-package the mower unit carefully so that the seals on
the hydraulic components are not broken or pulled off. Lay out parts to make location easy.
Inspect and clean all hydraulic hoses and fittings prior to installing them onto the tractor or mower. If dirt or
material is seen in any of the parts, they should be washed and cleaned thoroughly with an oil-compatible
solution. Do not blow the material further into a hose since this sometimes does not remove the foreign
material and can cause damage to hydraulic components down stream.