Filter
Top Products
ASSEMBLY
A96B 03/06 Assembly Section 3-10
© 2006 Alamo Group Inc.
ASSEMBLY
SHIELD ASSEMBLY
Remove and discard the two top bolts from the Center Gearbox. Attach Bracket (1) to the Center Gearbox with
M10 x 40 Bolts (2), and Flatwashers (3) in the same hole location. Install Shield (5) and retain with 1/2” Wing
Nut (4) (Figure ASM-R-0147).
JACKSHAFT BEARING SUPPORT ASSEMBLY
Attach the Jackshaft bearing support bracket (1) to
the tongue. Loosely attach bearing support by using
pivot bolt (3) with bushing (6). Install Bearing and
housing assembly (4). Install spacers (5) and bolt
(2) leaving installed loosely. Tighten bolt (2) NOTE:
Do not tighten to point of collapsing spacer (5).
Tighten pivot bolt (3) NOTE: Do not over tighten.
Make sure Carrier Bearing (4) pivots in supports
and complete assembly pivots on lower bolt. Slide
Jackshaft through bearing (4) slide spacer (7) on
Jackshaft (NOTE: Spacer goes between bearing
and Quick Disconnect Yoke.) See parts pages for
Jackshaft Bearing Support prior to Serial # 10705.
(Figure ASM-R-0148)
NOTE: Bearing should be pressed or locked
in place using loctite on jackshaft when shipped. If
not apply locktite 609 to shaft when installing
bearing.