Filter
Top Products
OPERATION
A96B 03/06 Operation Section 4-44
© 2006 Alamo Group Inc.
OPERATION
SHAFT OR TUBE TWISTED Over-loaded. Replace part and then slow down or
or raise Mower. Use protective device.
TUBE BROKEN IN WELDED Over-loaded. Replace part.
SEAM
YOKE BROKEN AT Over-loaded. Replace part.
EAR TIP
SLIP CLUTCH SLIPPING Excessive load. Reduce speed and/or raise cutter.
EXCESSIVELY
Springs weak. Replace Springs.
Improper adjustment. Re-adjust Slip Clutch
Too much power for Reduce ground speed and
Slip Clutch. material intake.
Friction Facings worn. Replace Facings.
Oil on Facings. Replace Facings.
Friction Facings glazed. Clean with emery cloth.
OIL BLOWING OUT Flat bottomed Vent Plug Replace with proper Vent Plug.
VENT PLUG or shallow cavity Plug. Cavity in Oil Plug should be
approximately 5/8”.
Oil level too high. Lower oil level to Plug.
DRIVELINE INTEGRAL Integral Shields deformed. Replace Shield.
SHIELDS RATTLING OR
NOT TURNING FREELY Nylon Bearing worn. Replace Nylon Bearing.