Filter
Top Products
12
7.03 Defect in cleaved fibers.
7.04 If fibers are properly cleaved:
- Remove the fiber viewer from the cleaver, and
- Remove the ribbon holder from the cleaver.
defective
Actuation Lever
Preload
Lever
Preload
Lever
8.0 Fiber Insertion
8.01 Move the actuation lever on the actuator tool all the way to the
right. Install the magnifying lens and pen light assemblies. Move
the preload levers to the up position.
8.04 Position the magnifying lens assembly and pen light assembly
over the splice.
8.03 Lay the back end of the ribbon holder against the backstop of the
holder guide track.
8.02 Place a Fibrlok Multi-Fiber Optical Splice into the actuator tool so
that the covers open toward the back of the actuator tool. Open
both covers completely.
Note: Carefully follow safety, health, and disposal information on
splice label or Material Safety Data Sheet.