Filter
Top Products
10
6.04 Lock the spacer in place by tightening the locking screw using the
supplied allen wrench.
6.05 Place the ribbon holder into the cleaver. Push the ribbon holder
against the cleaver spacer gauge .
6.06 Align the end of the ribbon coating to be within the slot in the
cleaver gauge. Adjust the ribbon position by pushing the ribbon
holder firmly against the cleaver gauge and pulling back on the
ribbon.
Note: Ensure that no fibers are crossed.
6.07 Close the cleaver clamping lid 1 .
6.08 Slide the scoring sled 2 across the bottom of the fibers.