162
This function prevents your
facsimile from sending to an
incorrectly dialed phone. With
this function set ON, the dialed
number will be checked against
the remote facsimile’s pro-
grammed Transmit Terminal ID
(TTI). The transmission will
only occur if the number dialed
matches the remote party’s
number.
You can turn the SECURITY
TX ON for a single transmis-
sion using this procedure.
NOTES:
• To change the default set-
ting of this function, refer
to page 143. The status
selection in this operation
will take precedence over
the default setting.
• The facsimile will auto-
matically return to its de-
fault status immediately
after that transmission is
complete.
Press:
+
+
+
+
Turn ON Security Transmis-
sion by pressing:
Load the document face down
in the Document Support (see
page 83).
Adjust the resolution and con-
trast if desired (see pages 84
and 85).
Enter the number of the remote
facsimile using any of the fol-
lowing dialing methods or you
may designate another option
at this point.
• One Touch Key Dialing
... See page 89
• Abbreviated Dialing
... See page 90
• Alphabet Dialing
... See page 91
• Keypad Dialing
... See page 92
Security Transmission
Load the Document
1
Display the
SECURITY TX Menu
2
Select the Option
3
Enter the Facsimile
Number
4
- TRANSMISSION OPTIONS
JAN-31 09:43 AM 100%
AUTO RECEIVE
1.ON
SECURITY TX
2.OFF
JAN-31 09:43 AM 100%
ENTER TEL NUMBER
MENU
The following screen is dis-
played. You may dial the re-
mote facsimile for your com-
munication job. The display will
return to the Standby Mode in
about 60 seconds if no keys
are pressed.
Turn OFF Security Transmis-
sion by pressing:
