56
Note:
You cannot activate the keylock when in the middle
of programming.
To turn on the keylock, press
FUNC
then press /
LIT
.
Keyboard
Locked
appears on the display for about 1
second.
Keyboard
Locked
appears when you press
any key after locking the keypad.
To turn off the keylock, press
FUNC
then press /
LIT
.
The scanner beeps once and
Keyboard
Unlocked
appears on the display about 1 second.
CHANGING THE DISPLAY
CONTRAST
1. Press
MANUAL
.
2. Press
FUNC
then press
9
.
Use
Up/Down
keys
to
set
contrast.
appears on the display.
3. Press or to select the contrast.
4. Press
ENTER
to set the display contrast.
CLONING THE PROGRAMMED
DATA FROM SCANNER TO
SCANNER
You can transfer the programmed data to and from an-
other PRO-92 using the supplied clone cable. To clone
the data, follow these steps.
1. Turn on both scanners.
2. Connect the supplied clone cable to each scanner’s
PC/IF
jack.
CLONE
MODE
UP
to
send,
remove
cable
to
exit
appears.
3. Press .
Yes=1,
No=Other
appears.
4. Press
1
to send the data to the other unit or press
any other key to cancel the operation.
The scanner sends the data. To exit the clone mode, re-
move the cable.
20-522.fm Page 56 Friday, September 17, 1999 12:46 PM
