45
Notes:
• You cannot turn off all banks. There must be at least
one active bank.
• You can manually select any channel in a bank,
even if the bank is turned off.
To turn on banks while scanning, press the number key
until the bank’s number appears.
MANUALLY TUNING A FREQUENCY
If desired, you can locate a frequency manually.
To tune to the frequency, follow these steps:
1. Press
TUNE
.
2. Use the number keys to enter the frequency.
3. Press
ENTER
.
4. Press to move up one tuning step. Press to
move down one tuning step. To move up or down in
1 MHz increments, press
FUNC
then press or .
To save the frequency into a channel (bank 9 only),
press
FUNC
then press
ENTER
.
Stored
@
9xx
appears on the display (xx: channel number).
When the scanner stops on a frequency while searching,
press
FUNC
then press
TUNE
. Press or to tune the
frequency.
Notes:
• The PRO-92 cannot change the step frequency
when it is in the tune mode.
• You can change the receiving mode in the tune
mode.
20-522.fm Page 45 Friday, September 17, 1999 12:46 PM
