Masterpage:Right-No-Heading
EN 55
Filename [DR-M10AG_AX_AA2_08Recording.fm]
Page 55 April 27, 2004 11:03 am
F
Enter the recording stop time.
Press we to select “STOP”, then press rt repeatedly to
set the desired stop time.
● Each press of rt advances/goes back the stop time in 1-min.
increments.
● To advance/go back the stop time in 30-min. increments, press
and hold rt.
G
Enter the channel position.
Press we to select “TV PROG”, then press rt
repeatedly to select the desired channel.
H
Set the other recording options as required.
Refer to step E in “G-CODE
TM
/SHOWVIEW
TM
Timer
Programming” (
੬ pg. 52).
I
Access the confirmation screen.
Press ENTER.
J
Complete timer programming.
Press ENTER.
● To programme another timer, repeat steps B – J.
K
Engage the unit’s timer mode.
Press # (TIMER). The unit turns off automatically and
“#” appears on the front display panel.
● To disengage the timer mode, press # (TIMER) again.
NOTES:
● The beginning of a programme may not be recorded. Also, if
the 1st programme’s recording stop time and the 2nd
programme’s recording start time is the same, the ending of the
1st programme may not be recorded.
● If the copy limited programme is received during timer-
recording, the unit enters Record Pause mode. Recording starts
again if it is switched to a recordable broadcast during the
time you programmed.
Satellite Receiver Users
To timer-record a satellite broadcast using Manual Timer
Programming:
A Perform “Manual Timer Programming”. Enter “L-2” for the
channel position.
B Set the satellite receiver to the appropriate channel before
the selected programme begins.
C Leave the satellite receiver’s power on.
DR-M10SAG_AX_AA2_01.book Page 55 Thursday, May 6, 2004 10:46 AM
