38
Repeat the above steps and until each level is adjusted as desired.
4
• Each time these buttons are pressed, “” is moved to
the corresponding LFE level mode.
• Each time these buttons are pressed, the LFE level can be
adjusted within the range of either -10~0 dB for Dolby
Digital program sources or -10~+10 dB for DTS and
MPEG program sources.
• In general, we recommend the LFE level for Dolby
Digital program sources to be set at 0 dB and at +10 dB
for DTS program sources.(However, the recommended
LFE level for some early DTS program sources is 0 dB.)
If the recommended levels seem too high, lower the
setting as necessary.
Press the CURSOR UP()/DOWN() buttons to select the LFE LEVEL CONTROL, then press the
ENTER button.
1
Press the CURSOR UP()/DOWN() buttons to select the desired LFE level mode.
2
Press the CURSOR LEFT()/RIGHT() buttons to adjust the selected LFE level as desired.
3
When selecting the LFE LEVEL CONTROL
