A SERVICE OF

logo

BES-941BC • BES-1241BC
53
Chapter 2 Embroidering Procedures
Switches at Machine Heads
BES-941BC BES-1241BC
Between head No. 1 and No. 2
Between head No. 3 and No. 4
Between head No. 2 and No. 3
Stop switch
Stops embroidering operation. "Release stop SW to operate!" is displayed on
the screen as soon as the machine stops.
Refer to "Resetting Machine Stop" (
page 125) to stop flashing.
Power switch
Starts embroidering. Holding down this switch executes embroidering at a low
speed.
When resuming embroidering after a stop, release stop before pressing this
switch. Refer to "Resetting Machine Stop" (
page 125) for details.
Switches on Tension Plate
THREAD SENSOR lamp
HEAD switch
MENDING lamp
MENDING switch
STEP BACK/FWD switch
Stop switch
Power switch
Stop switch
START
START
Power switch