A SERVICE OF

logo

Open as PDF
next previous
Chapter 1 Preparation of Embroidery Machine
BES-941BC • BES-1241BC
27
4. Mount four drilling bolts i, spring washers !0, flat washaers !1 each on the rear of F table R
t, M y, and L u.
5. Mount four thumb bolts on the steel pipe below the front leg.
6. Insert the pins attached to the rear of the F table R t, M y, and L u into the cover o on the
leg. Adjust the height of the F table guide U q and the F table support F e so that the table
top surface will become 1 mm lower than the bed top surface. After adjustment is finished,
tighten each bolt securely.
7. Mount a drilling bolt i, a spring washer !0, and a flat washer !1 in section (A) of F tables R t
and L u.
q
e
Lower by 1 mm
Pin
i
o
u
y
t
(A)
(A)