Zenoah G3200EZ Chainsaw User Manual


 
50
Make sure every cutter has the same length and edge
angles as illustrated. (F11-3)
(4) Cutter length
(5) Filing angle
(6) Side plate angle
(7) Top plate cutting angle
GUIDE BAR
•Reverse the bar occasionally to prevent partial
wear.
The bar rail should always be a square. Check for
wear of the bar rail. Apply a ruler to the bar and the
outside of a cutter. If a gap is observed between
them, the rail is normal. Otherwise, the bar rail is
worn. Such a bar needs to be corrected or replaced.
(F11-4)
(1) Ruler
(2) Gap
(3) No gap
(4) Chain tilts
This saw is equipped with one of the following low
kickback bar/chain combinations:
WARNING
F11-3
F11-4
11. Maintenance of Saw Chain and Guide Bar
English