Zenoah G3200EZ Chainsaw User Manual


 
32
8. Operation
English
When adjusting, take the following steps:
Be sure to adjust the carburetor with the bar chain
attached.
1. H and L needles are restricted within the number of
turn as shown below.
H needle : –1/4
L needle : –1/4
2. Start engine and allow it to warm up in low speed for
a few minutes.
3. Turn idle adjusting screw (T) counter-clockwise so
that saw chain does not turn. If idling speed is too
slow, turn the screw clockwise.
4. Make a test cut adjust the H needle for best cutting
power, not for maximum speed.
(1) L needle
(2) H needle
(3) Idle adjusting screw
CHAIN BRAKE
This machine is equipped with an automatic brake to
stop saw chain rotation upon occurrence of kickback
during saw cutting. The brake is automatically operated
by inertial force, which acts on the weight fitted inside
the front guard.
This brake can also be operated manually with the
front guard turned down to the guide bar.
To release the brake, pull up the front guard toward the
front handle till a “click” sound is heard.
(1) Release
(2) Activate
(3) Front guard
Be sure to confirm brake operation during daily
inspection.
How to confirm:
1) Turn off the engine.
2) Holding the chain saw horizontally, release your
hand from the front handle, hit the tip of the guide
bar to a stump or a piece of wood, and confirm
brake operation. Operating level varies by bar size.
IMPORTANT
NOTE
(1)
(2)
(3)
F8-8
(1) (2)
(3)
F8-9
F8-10