Filter
Top Products
28
8. Operation
English
It is very dangerous to run a chainsaw that mounts
broken parts or lacks any parts.
Before starting engine, make sure that all the parts
including bar and chain are installed properly.
■ STARTING THE ENGINE
1. Fill fuel and chain oil tanks respectively, and tighten
the caps securely. (F8-1)
(1) Fuel
(2) Chain oil
2. Set the switch to “I” position. (F8-2)
(1) Switch
3. Continuously push the priming bulb until fuel comes
in the bulb. (F8-3)
(1) Priming bulb
4. Pull out the choke knob completely to close the
choke. (F8-4)
(1) Choke knob
(2) Close
(3) Open
When restarting immediately after stopping the engine,
you need not to pull out the choke knob.
5. While holding the saw unit securely on the ground,
pull the starter rope vigorously. (F8-5)
Do not start the engine while the chain saw hangs
in one hand. The saw chain may touch your body.
This in very dangerous.
WARNING
NOTE
WARNING
(1)
(2)
(3)
(1)
(2)
(1)
(1)
F8-1
F8-2
F8-3
F8-4
F8-5