Filter
Top Products
Troubleshooting Reference
37
Battery Status
LED is red and
has not
changed to
green after 24
hours of
charging.
The voltage at the AC wall
outlet is less than
120 VAC.
Use AC wall outlet that supplies
120 V AC.
Continue to charge the unit for
another 12 hours; the unit will be
ready to use even if the Battery
Status light remains red.
The engine
being boosted
will not start.
XPower Powerpack
battery is not fully
charged.
The engine condition is
poor.
The engine start capacity
exceeds the XPower
Powerpack boosting
capability.
Recharge the XPower
Powerpack battery.
Have the engine serviced.
Use a higher power XPower
Powerpack.
The battery
clamps of the
boosting
cables
measure zero
volts.
Boosting power switch is
OFF.
XPower Powerpack
battery is discharged.
Turn boosting power switch ON.
Recharge XPower Powerpack.
The
compressor
runs, but won’t
inflate.
The valve connector may
not be securely placed on
the valve stem.
The item being inflated
may have a leak.
Make sure the valve connector is
securely placed on the valve
stem before closing the thumb
latch.
Make sure the item being
inflated doesn’t have a leak.
Check the compressor hose for
any breaks or leaks.
Table 5-1
Troubleshooting reference
Problem Possible Cause Solution
XPower_PP_200_Plus.book Page 37 Monday, October 23, 2006 2:57 PM