Filter
Top Products
16 Operation
MAN0884 (08/15/2011)
CLEANING
After Each Use
■ Remove large debris such as clumps of dirt, grass,
crop residue, etc. from machine.
■ Inspect machine and replace worn or damaged
parts.
■ Replace any safety decals that are missing or not
readable.
Periodically or Before Extended Storage
■ Clean large debris such as clumps of dirt, grass,
crop residue, etc. from machine.
■ Remove remaining debris using a low-pressure
water spray.
1. Be careful when spraying near scratched or torn
safety decals or near edges of decals as water
spray can peel decal off surface.
2. Be careful when spraying near chipped or
scratched paint as water spray can lift paint.
3. If a pressure washer is used, follow the advice
of the pressure washer manufacturer.
■ Inspect machine and replace worn or damaged
parts.
■ Sand down scratches and the edges of areas of
missing paint and coat with Woods spray paint of
matching color (purchase from your Woods dealer).
■ Replace any safety decals that are missing or not
readable (supplied free by your Woods dealer). See
Safety Decals section for location drawing.
PRE-OPERATION CHECK LIST
(OWNER'S RESPONSIBILITY)
___ Review and follow all safety rules and safety
decal instructions on pages page 5 through
page 9.
___ Check that all safety decals are installed and in
good condition. Replace if damaged.
___ Check that all shields and guards are properly
installed and in good condition. Replace if dam-
aged.
___ Check that all hardware and cotter pins are prop-
erly installed and secured.
___ Check that equipment is properly and securely
attached to tractor.
___ Make sure driveline spring-activated locking pin
or collar slides freely and is seated firmly in trac-
tor PTO spline groove.
___ Inspect area and remove stones, branches or
other hard objects that might be thrown, causing
injury or damage.
___ Do not allow riders.
___ Check the drive chain for tension. If too loose,
adjust the idler sprocket. A 1/4" sag in the bottom
span is satisfactory.
___ Check all lubrication points and grease as
instructed in "Service, lubrication information".
Make sure the PTO slip joint is lubricated and that
the gearbox fluid levels are correct.
___ Set tractor PTO at correct rpm for your equip-
ment.
___ Check that all hydraulic hoses and fittings are in
good condition and not leaking before starting
tractor. Check that hoses are not twisted, bent
sharply, kinked, frayed or pulled tight. Replace
any damaged hoses immediately.
___ Make sure tractor ROPS or ROPS CAB and seat
belt are in good condition. Keep seat belt
securely fastened during operation.