Filter
Top Products
Assembly 27
15148 (Rev. 2/9/2007)
Figure 28. Scalping without Front Rollers
Figure 29. Front Rollers Reduce Scalping
OPTIONAL EQUIPMENT INSTALLATION
Before working underneath, block mower
securely. Hydraulic system leak down and failure of
mechanical or hydraulic system can cause equip-
ment to drop.
Always wear relatively tight and belted clothing
to avoid getting caught in moving parts. Wear
sturdy, rough-soled work shoes and protective
equipment for eyes, hair, hands, hearing, and head;
and respirator or filter mask where appropriate.
Caster Installation
L59 Caster Installation
Remove skids.
Insert 3/8 x 1-1/4" bolts through outer frame rail. Mount
caster arm over bolts.
Insert two 3/8 x 1-1/4" bolts through the front two holes
of outer frame. Mount caster arm over bolts, making
sure offset is outward. Install side skid and secure with
lock washer and nut.
Raise mower deck slowly to check for any interference
between casters and tractor.
Figure 30. Caster Installation L59
L306 Caster Installation
Figure 31. Caster Installation L306
Mount casters on L306 mowers to the outside deck
rails. Attach rear of caster arm in fourth hole from front
of deck rail with a 3/8 x 1-1/2" bolt and secure with lock
washer and nut. The arm may be mounted in the third
hole to obtain more height and caster adjustment.
Attach right and left adjustment brackets, offset down
and in front hole as shown, on each side of deck angle
and inside the side skid. Use two 1/2" flat washers as
spacers at the rear side shield hole.
Select the desired cutting height and install adjustment
brackets to caster arm with 1/2 x 1-3/4" bolts and
secure with 1/2" flanged lock nuts.
Adjust side skids to ride at least 1/2" above ground.
A WARNING
A CAUTION