Filter
Top Products
34 Assembly
MAN0137 (9/14/01)
Assembly Instructions
Cont’d
Install Transport Lock-Up
1. Slide lock-up bar (2) into left front lift stop (1).
1. Attach lock-up bar extension (3) using 1-1/4" hex
bolts (10) and 3/8" locknut (9).
2. Thread 1/2" jam nut (8) and clevis yoke (5) onto
lock-up bar to obtain the 32" dimension shown in Fig-
ure 27. Hand tighten jam nut (8) against clevis yoke
(5).
3. Secure clevis yoke (5) to rear rockshaft assembly
(4) with clevis pin (6). Flat washers (11) must be
installed as shown in Figure 26.
4. Secure clevis pin (6) with cotter pin (7). Do not
spread cotter pin at this time.
5. Install handle grip (12) on lock-up bar (2)
1. Front lift stop
2. Lock-up bar
3. Lock-up bar extension
4. Rear rockshaft assembly
5. Clevis yoke
6. 1/2 x 1-3/4" Clevis pin
7. 3/16" x 1 Cotter pin
8. 1/2" Jam nut
9. 3/8" Locknut
10. 3/8 x 1-1/4" Bolt
11. 1/2" Flat washer
12. Handle grip
Figure 26 Transport Lock-Up Installation
Figure 27 Lock-Up Bar Length
12
11
10
9
8
7
6
5
4
2
3
1
CD4178
32"
CD4201B