Filter
Top Products
Hydraulic Installation 17
MAN0064 (Rev. 7/20/2007)
1023582 Hose Kit
Install Hoses
1. Attach straight end of hoses (1) to the IN, OUT
and PBY ports of the loader control valve.
2. Locate the fill plug on the top of right rear axle
and remove.
3. Install adapter (3) and adapter (11) into opening.
4. Attach hose from the PBY port on the loader
control valve to elbow (12) in the PBY (N) port on
the front of adapter plate (2).
5. Attach hose from the IN port on the loader control
valve to adapter (21) in the PRESSURE (P) port
on the side of adapter plate.
6. Attach hose from the OUT port on the loader
control valve to adapter (11) in the RETURN port
on the top of the rear axle.
1. 1001422 Hose, 86" x 3/4 JICF x 3/4 JICF
2. 1001421 Adapter plate
3. 1001419 Adapter, 7/8 O-ring F x 1-3/8 Trd M
3. 1001657 Adapter, 7/8 O-ring F x 1-5/8 Trd M
11. 316016 Adapter, 3/4 JICM x 7/8 ORBM
12. 316004 Elbow, 3/4 JICM x 3/4 ORBM 90°
21. 61 Adapter, 3/4 JICM x 7/8 ORBM 90°
Figure 23. Hydraulic Fitting Installation
Install Hose Hanger
1. Install hose hanger bracket (14) under platform
between brake pedals and chassis as shown in
Figure 24.
2. Secure with hex head cap screw (18), flat
washers (19), and lock nut (17).
3. Route hoses through hose hanger bracket and up
behind right platform as shown in Figure 18.
4. Secure hoses in hose hanger with lock pin (13).
5. Secure hoses every 20 inches with plastic ties.
14. 58033 Hose hanger bracket
13. 58047 1/4 x 2-1/2 Lock pin
17. 6778 5/16 NC Lock nut
18. 6250 5/16 NC x 1-1/4 HHCS
19. 4378 5/16 Standard flat washer
Figure 24. Hose Hanger Installed
Figure 25. Hose Routing