16 Hydraulic Installation
MAN0064 (Rev. 7/20/2007)
1023582 HOSE KIT
General Description
These set up instructions are for operating the LU126
loader using a single lever control valve mounted to
the right loader mount bracket as shown in Figure 21.
To use this hydraulic connection, hose kit 1023582
must be connected between loader control valve and
tractor hydraulics.
Install loader control valve before proceeding.
NOTICE
■ If hydraulic lines are not connected as shown
in this manual, the control valve may be damaged.
A blocked outlet (RETURN) or improper hose con-
nection will cause pressurized oil to enter the
return circuit and damage the valve.
Figure 21. Control Valve Installed
Install Adapter Plate
NOTICE
■ Removal of the accessory plate or remote
valves with a load being held on the 3-point hitch
will result in escape of high pressure oil and sud-
den, uncontrolled drop of 3-point hitch arms.
Before attempting to install this kit, the following must
be observed:
● Shut off engine, place transmission in neutral,
and apply parking brake.
● Fully lower any equipment supported by the trac-
tor remote hydraulic valves, if so equipped. Acti-
vate any remote valves to relieve all hydraulic
pressure in the remote circuits.
● Fully lower the 3-point hitch.
1. Thoroughly clean the top front of the hydraulic
accessory plate.
2. Install elbow (12) and adapter (21) to adapter
plate (2).
3. Remove accessory plate cover (A). Be careful not
to disturb the O-rings that need to stay with the
cover plate when it is removed.
4. Install O-rings to bottom of adapter plate (2). Use
petroleum jelly to keep the O-rings in the
counterbores.
5. Place the adapter plate over hydraulic opening.
6. Place the accessory plate cover onto the adapter
plate. Make sure O-rings stay in the counter-
bores.
7. Secure with hex head cap screws and flat washer
as shown in Figure 22.
Figure 22. Adapter Plate Installed
A. ----- Accessory plate cover
2. 1001421 Adapter plate
10. 1001423 7/16 NC X 4-3/4 HHCS
12. 316004 Elbow, 3/4 JICM x 3/4 ORBM 90°
15. 21549 7/16 NC x 3 HHCS
16. 21548 5/16 NC x 3-1/4 HHCS
19. 4378 5/16 Standard flat washer
21. 61 Adapter, 3/4 JICM x 3/4 ORBM
