Filter
Top Products
Maintenance Instructions CLEANING
62
NOTE: Use care when cleaning the lter ele-
ment. The lter element and/or seal surface
may be damaged by tapping too hard or hitting
on an uneven surface or sharp edge. Washing
the element in water or cleaning solution is not
recommended. Do not try to clean the element
with compressed air. Remember replacing a l-
ter is less expensive than replacing a dusted
engine.
4. Use a bright light inside the element to inspect
for damage. Check the element very carefully
for pin holes or other damage that will allow
dirt to leak through the paper media. Replace
element if necessary.
5. Check the condition and resilience of the radial
sealing surface (inside of the open end) of the
lter. Replace the lter if any cracks, tears, or
other damage to the sealing surface are noted.
6. Without removing, visually inspect the condition
of the safety lter for damage or holes. The
safety lter should only be removed for
replacement yearly (or when dirty or damaged).
IMPORTANT: Prior to removing the safety lter,
make sure the inside surface of the air cleaner
canister is clean. This will minimize the risk of
dirt entering the outlet tube which can cause pre-
mature engine wear.
7. After removing the safety lter, use a clean,
damp cloth and wipe the interior of the air clean-
er canister clean. Use special care to clean
both the inside and outside surfaces of the
outlet tube.
IMPORTANT: Any dust left on the inside of the
outlet tube will go into the engine and cause wear.
8. Check the outside surface of the outlet tube for
smoothness and cleanness (this is the sealing
surface).
9. Insert and seat the safety lter and primary ele-
ment carefully into the canister, applying pres-
sure at the outer rim of the lter; not at the ex-
ible center. Make sure the lter element is
completely in place before installing the cover.
IMPORTANT: DO NOT use the cover latches
to force the lter into the canister -- the cover
should t on with no extra force.
NOTE: DO NOT use petroleum based lubri-
cants on the sealing surfaces of the lter; use
tal cum powder or dry silicone lubricants if re-
quired for lter installation.
Radial Sealing
Surface
Primary
Filter Element
Canister
Outlet Tube
Safety Filter
Air Filter Element Replacement
10. Install the cover with the word “TOP” properly
oriented to the top of the canister. Give the
cover a slight twist as it reaches the canister to
make sure the tab inside the cover goes into a
slot, otherwise the cover will not t properly.
Make sure both the top and bottom cover
latches are securing the cover in place.
Dust Ejection
Valve
Cover Latch
Cover Latch
Orient to Top
of Canister
Proper Orientation of Air Cleaner Cover
11. Check the air intake hose for cuts, nicks, cracks,
etc., and the hose clamps for tightness.
12. Reset the air lter restriction gauge (press but-
ton on the end of the indicator).