Filter
Top Products
Operating Instructions
26
CONTROL IDENTIFICATION, LOCATION, AND
FUNCTION
CAUTION
Before operating the mower, become famil-
iar with the location and function of all op-
erator controls. Knowing the location,
function, and operation of these controls is
important for safe and efcient operation
of the mower.
Ignition Switch
The ignition switch is located on the left front of the
body and is used to start and stop the engine. The
switch has three positions: “O” is the OFF position,
RUN is the position the key returns to after starting,
and “S” is the START position. When starting the
engine, turn the key clockwise to the “S” position.
Do not hold the key in the “S” position longer than
10 seconds. If the engine does not start, return the
key to the “O” position for at least 60 seconds before
making a restart attempt. Prolonged cranking can
damage the starter motor and shorten battery life.
Release the key when the engine starts, and it will
return to the RUN position. To stop the engine, rotate
the key counterclockwise to the “O” position.
Engine Choke
The choke control lever (black knob) is located on
the left side of the seat. To start a cold engine, move
the choke control forward to the ON position. After
engine starts, move the choke control toward the
OFF position, keeping enough choke to allow the
engine to run smoothly as it warms up. As soon as
possible, move the choke to the OFF position. A
warm engine requires little or no choke for starting.
IMPORTANT: Make sure the choke is in the OFF
position during normal engine operation; running
with the choke in the ON position CAN damage the
engine.
Operating Controls
Ignition Switch
Key Positions
OFF
START
ON
Choke
Throttle
Forward Speed
Control (FSC)
Parking
Brake
Blade Clutch
(PTO)
Ignition Switch
(See Inset)
Light Switch
(Optional, Not Shown)
7 Amp
Circuit Breaker
Hourmeter
Steering
Levers
Front Body Latch
Release (Not Visible)
Oil Pressure
Warning Horn