Filter
Top Products
WARNING: The use of alcohol, drugs, or medication can greatly increase the risk of fatal HYPERTHERMIA.
PAGE 2
Reading and understanding these warnings will allow you to reduce the risk of causing inadvertent damage to your spa, your surroundings,
or yourself. Read these warnings carefully.
DO Make sure the spa is connected to a Ground Fault Circuit Interrupter (GFCI). Test the GFCI before each use.
DO Test the water with your hand before entering the spa to be sure it is comfortable.
DO Remember that wet surfaces can be slippery. Take care when entering and existing the spa.
Only enter by way of the step(s) in the spa. Do not step on edges or filter lids.
DO Keep the thermal cover on the spa when it is not in use, empty or full.
DO Maintain proper water pH (7.4-7.6) and clean filter cartridge weekly. Refer to Water Maintenance section.
DO Take steps to prevent the intrusion of sand and dirt into the spa.
DO Maintain water level to 1” above the highest jets. The jets can spray water out of the spa if the water
level becomes too low.
DO Shut off circuit breaker to the spa before draining the spa, while it is empty and while filling it.
DO Place only on surfaces that can withstand the floor loading requirements of your spa.
If you do not know the rating of your floor, consult an architect or engineer before filling.
DO Install the spa only on floors or areas that can withstand repeated exposure to water (tile, brick, etc.)
DO Clean the filter cartridge weekly.
DO NOT Store chemicals in the spa’s equipment compartment.
DO NOT Open the electrical control box. They are no user serviceable parts inside.
DO NOT Operate the pump(s) on hi-speed for extended periods of time with the cover on. Extended hi-speed
pump operation will cause a slow heat build-up due to water friction, which could trip the spa’s hi-
limit thermostat.
DO NOT DIVE INTO SPA
SAVE THESE INSTRUCTIONS
SITE SELECTION
Structure: The spa should always be placed on a structurally
strong, smooth and level surface. Concrete is preferred.
The xStream spa models have a loading capacity of
850kg/m
2
- 930kg/m
2
(175lbs. - 190lbs. /sq. ft).
LOCAL CODES:
There may be certain restrictions and/or requirements that
are particular to your locality.
MAINTENANCE:
Trees, lawn, placement surfaces, etc. can create extra work
in keeping your spa area clean and safe. Please be advised
that placing your spa near dirt or trees may increase the
amount of debris inadvertently brought into the spa water
on the feet of users or by the wind. The intrusion of this
debris into the spa water may cause harm to your equip-
ment as well as the spa surface and is not covered under
warranty.
PRIVACY AND WIND SHIELDING:
A sheltered environment can result in lower operating and
maintenance costs. You may also want to take into consideration
your privacy during times of the year when trees may be barren,
having the spa located where you have a view of a peaceful
sunset, where you may be able to catch soothing breezes,
or your view and the view of your neighbors may also be
something that you should address prior to the final installa-
tion of your spa.
CLEARANCES
CHECK THE FOLLOWING AREAS PRIOR TO SPA DELIVERY*
1. TREE BRANCHES
Clearance for spa passage.
2. TIGHT CORNERS
Make sure there is space to maneuver.
3. STORAGE SHEDS, DOG HOUSES, WOOD PILES
Remove out of the way.
4. OVERHANGS AND GUTTERS
Anything overhead, as well as drain pipe loca-
tions, must allow for spa passage.
* Most installations require a crane. Estimated
dry weight of spa is 1795kg (3950 lbs).
SET UP AND INSTALLATION INSTRUCTIONS
MANUFACTURER’S DO’S AND DON’TS