Filter
Top Products
TO CHANGE TO
INDIVIDUAL DAYS
OF THE WEEK:
7 – Saturday
6 – Friday
5 – Thursday
4 – Wednesday
3 – Tuesday
2 – Monday
1 – Sunday
continues on next
p
a
g
e
USE ARROWS TO
CHANGE TEMPERATURE
USE ARROWS TO
CHANGE ºF to ºC
12/24
HOUR
MINUTES
MONTH
DAY
YEAR
GOES BACK
TO THE
BEGINNING
USE ARROWS TO CHANGE
THERAPY PROGRAMMING INSTRUCTIONS
E. HEAT DAYS & TEMPERATURE ............................................
Your spa is pre-programmed from factory to heat “All” days, “hd=A”. It has
however the ability to be programmed for different temperatures on different
days of the week. To do so, follow these steps:
Example: Let's assume that you don’t normally use the spa between Mondays
and Thursdays and you want to save on your electric bill by reducing the
spa’s energy consumption.
1. While the display shows “hd=A” press . The
display will show the heat day. Press
again
until the desired heat day is selected .......................
2. Press
to display temperature for the day
selected. Press and hold
to lower temperature
to, for instance, to 80ºF (27ºC). Press
to increase the temperature.
3. To check or adjust the temperature on another day, press
to cycle through the
program until the display shows “hd=A” again. Then repeat steps 1 through 3 to do
the same for Wednesday (hd=4), Tuesday (hd=3) and Monday (hd=2).
NOTE: If you programmed different temperatures at different days, DO NOT alter the
temperature setting after the display shows “hd=A”. If you do so, “All” days will revert
to the newly set temperature.
F. TEMPERATURE – ºF or ºC..................................................
Your spa is pre-programmed from factory to display temperature in degrees
Fahrenheit (ºF). Use the arrow keys to change between degrees Celcius (ºC)
and degrees Fahrenheit (ºF).
G. CLOCK AND CALENDAR SETTING ......................................
The display will sequence through the time and calendar settings as
is
pressed.
Sequence is: “H=12” – 12-hr or “H=24” – 24-hr clock
Hours setting
Minutes setting
Month setting
Day setting
Year setting
Use the arrow keys to change the setting of the blinking digits.
H. DISPLAY ...........................................................................
The Control Center display can be inverted to allow easier reading from inside
the spa. To do so, while the display shows “FLIP” use
or
to invert
the display back and forth.
To exit programming mode, press , or at any point in the
sequence or wait for 10 seconds (without pressing any button).
a. hd=7 Saturday
b. hd=6 Friday
c. hd=5 Thursday
d. hd=4 Wednesday
e. hd=3 Tuesday
f. hd=2 Monday
g. hd=1 Sunday
PAGE 8