Filter
Top Products
SWIM OPERATING INSTRUCTIONS
TURNING ON THE LIGHT
Standard Light: Press to turn light on and off.
LED Light
: Press once to turn underwater
lights on. Pressing a second time will turn on
Aquabrite/ Chromatherapy, if so equipped.
Pressing a third time will turn lights off.
For color/intensity programming, refer to
Aquabrite/Chromatherapy instructions below.
AQUABRITE/CHROMATHERAPY
(OPTIONAL)
The Aquabrite/Chromatherapy option is activated
by pressing the
button on the spa control
center.
Programming the lights can be done once the
display reads “L=XX”.
The
button increases and the button
decreases light intensity.
The button is used to select different light
color settings. This selection may be changed at
any time the display reads “L=XX”. If the display
does not read “L=XX”, press the
button on
the spa control center until it does.
Available color combination settings:
L=00 Lights Off
L=01 White (Red, Blue and Green LEDs on)
L=02 Blue
L=03 Green
L=04 Red
L=05 Strobe effect Red/Green/Blue
L=06 Gradual change Red/Green/Blue
L=07 Combination Colors: Blue/Green
L=08 Combination Colors: Red/Green
L=09 Combination Colors: Red/Blue
L=10 Music (Stereo must be on to work)
The lighting system will automatically turn itself off
after three (3) hours.
SURROUND STEREO
(OPTIONAL)
The stereo option allows you to
listen to FM stations or any other
audio source connected to the
“Line” input.
ACTIVATING THE STEREO SYSTEM
- The stereo is
turned on by simultaneously pressing the and
buttons on the spa control center. The stereo
will automatically be taken to the volume control.
LOUDNESS
– While the display shows “Loud”, you
may adjust the volume level by pressing the
or
buttons. The volume range is L=00 (off)
through L=10 (the loudest volume).
BASS - While in the volume mode, press the
button to change to Bass mode. Bass can now be
adjusted by pressing the or buttons and
ranges from B=00 through B=10.
AUDIO SOURCE
- From Bass Mode, press to
select source (use the or buttons to
change):
S=F Stereo will enable FM station tuning.
S=L Stereo line input is enabled.
FM TUNING
- If FM source is selected, press to
advance to station tuning. The control pad display
will show the FM frequency.
Station scanning starts by pressing
or
buttons.
CD/MP3 PLAYER
– If source is S=L (Line input), you
can connect an optional CD player or any other
personal stereo device, such as a walkman or MP3.
Pressing
again will make the controller cycle
back to Loudness.
PAGE 12