Filter
Top Products
SWIM OPERATING INSTRUCTIONS
SETTING TEMPERATURE FOR A DAY.
Press this button to display water temperature.
Press these buttons to select the desired temperature.
NOTE: For full instructions on programming your ICS
TM
controller, go to the SWIM PROGRAMING
INSTRUCTION section on page 13.
IMPORTANT:
When your spa is activated or temperature is adjusted, the spa goes through a 2-½ minute calibration cycle. The
controller will evaluate the temperatures at the heater and water in the spa and will determine
proper operation and heating needs. The calibration process is indicated by a flashing of
the Ò
(sun) icon on the Control Center display.
BADU-STREAM II JETS
(Standard on PRO & DUOPRO MODELS • Optional on XSTREAM)
To start swimming, jogging or running it is
suggested that the two nozzles be pointed slightly
inward and slightly upward so that the water
“breaks” approximately 3 feet in front of the
BADU-STREAM II.
Start the jets by pressing the
button. You can
control water flow strength by adjusting the air
control and jet nozzles.
The air control is located above the jets and varies
the mixture of air into the water flow and creates a
unique, invigorating, bubble bath effect. It will also
add additional resistance to swim against.
BADU-STREAM II's adjustable flow nozzle enables
swimmers to regulate the volume of water
released through the jets. Turning the nozzle
clockwise reduces the flow.
The swivel nozzle of the BADU-STREAM II can be
positioned in various directions, allowing swimmers
to use various swim styles.
Under certain conditions it is possible that the
current “drifts off” the left or the right from the
middle due to water bouncing off the back wall. In
the event that it interferes with your swimming
action, turn the jets off and restart them after the
water flow dies.
WARNING!
• DO NOT USE or operate the
BADU STREAM II if the
square, anti-entrapment
cover is missing, broken, or
loose.
• Consult your physician before attempting
any strenuous exercise.
• The BADU-STREAM II jets do not close
water flow all the way. Overturning Jet
Nozzle can cause breakage.
V-STREAM JETS
(STANDARD ON XSTREAM)
The V-Stream Jets are powered by two 4HP high
powered pumps.
operates the 2 top jets (Pump 1).
operates the 2 bottom jets (Pump 2).
The V-Stream Jets are adjustable by using the
center nozzle.
PAGE 11
NOTE: This setting only alters the
temperature for the rest of the day.
Go to section B. HEAT DAYS &
TEMPERATURE on page 13 to make
permanent changes.