Filter
Top Products
8s
xStream
xStream Pro
xStream Duo Pro
GOES BACK TO THE BEGINNING OF
THE ADVANCED SETTINGS
USE ARROWS TO
CHANGE VALUE
SWIM ADVANCED PROGRAMMING INSTRUCTIONS
DO NOT ENTER THIS SECTION UNLESS INSTRUCTED BY A QUALIFIED TECHNICIAN
** IMPROPER CHANGES MAY CAUSE MALFUNCTION OR DAMAGE YOUR SPA AND MAY VOID THE WARRANTY! **
ADVANCED FEATURES SETUP
To exit programming mode at any point in the sequence, press any button other than , or , or wait for 10
seconds (without pressing any button).
A1. SETUP ("SU") .................................................................
While the display shows “SU” enter the Advanced Programming Menu by holding
down
for 8 seconds.
A2. PUMP SETUP...................................................................
The Swim Control of the xStream spas has been factory programmed, and
should be:
xStream “P=3C” ONLY.
xStream Pro and Duo Pro “P=2C” ONLY.
A3. POWER SERVICE LEVEL ..................................................
The Swim Control of the xStream spas should be set to “S=0” ONLY.
This indicates that the heater will shut off when any pump is turned on high
speed, except for the filtration (circulation) pump.
Warning! Changes to this setting may cause inadvertent breaker
tripping and strain your power connections. If so, this would
void your warranty.
A4. COUNTRY........................................................................
This setting is used for the FM Stereo tuning, if so equipped. It should be set to
“CO=U” for the US and Canada, “CO=E” for Europe and “CO=J” for Japan.
A5. AUX BUTTON (BLOWER).................................................
This setting is not applicable to the Swim Control.
A6. PUMP 2 SPEED SETTING.................................................
This setting should be set to “LS1-” ONLY. Changing this setting will cause swim
pumps to follow button commands incorrectly.
A7. PRIME CYCLE AT STARTUP .............................................
This step, if present, turns the pumps on for a minute or two every time power is
applied to the spa, to prime the pumps.
Default setting is “Pr= -”.
To exit programming mode at any point in the sequence, press any button other than
, or , or wait for 10
seconds (without pressing any button).
PAGE 15