Filter
Top Products
NOTE: FOR BEST RESULTS, READ EACH STEP CAREFULLY AND ENTIRELY BEFORE PROCEEDING TO THE NEXT.
FILLING YOUR SPA
Wipe the interior of the spa with a damp, soft cloth to
remove any residue that may be on the surface. Fill with
a garden hose by inserting the nozzle of the hose in the
filter inlet (After filling is complete, remember to put the
filter cartridge in place prior to starting the spa).As the
spa is filling, check in the equipment access area for any
leaks. On occasion, it may be necessary to hand tighten
a union fitting that may have come loose during transit.
Continue to fill to the water line as marked or top of
baffles in swim area.
NOTE: If your water is extremely hard, it is preferable to
fill the spa halfway with hard water and the rest with
softened water.
Never fill the spa entirely with softened water.
GFCI
The GFCI is a very important safety device and the
National Electric Code requires that all spas are GFCI
protected.
The GFCI shuts off the electricity in a fraction of a
second if there is a short anywhere in the system.
TESTING THE GFCI
It is recommended that the GFCI be tested prior to each
use. Test as follows:
1. Push the TEST button on the GFCI. The RESET button
will trip out, the Spa Control Center(s) display(s) will
go out.
If this does not happen, DO NOT USE spa.
CALL your dealer FOR ASSISTANCE.
2. If the GFCI tests properly, firmly push the RESET
button back into place. The Spa Control Center(s)
display(s) will come back on.
If this does not happen, DO NOT USE spa.
CALL your dealer FOR ASSISTANCE.
If the GFCI trips by itself at any time, firmly press the
RESET button back into place and perform the above
tests.
If this does not happen, DO NOT USE spa.
CALL your dealer FOR ASSISTANCE.
PAGE 5