Filter
Top Products
SNOW THROWING PATTERNS
Use the snow clearing pattern shown in
Figure 4-4 when snow can only be thrown
to one side. Begin throwing snow closest
to the side opposite where it can be
thrown and direct the discharge away
from that side. When turning the unit
around after each pass, rotate the dis-
charge chute as you proceed so snow
continues to be thrown in the proper
direction.
Use the snow clearing pattern shown in
Figure 4-5 to throw snow to both sides.
When turning the unit, rotate the dis-
charge chute as necessary to throw snow
in the proper direction.
Section 4: Operation
Do not use your hands or feet to dislodge
snow from inside the collector
(auger/impeller) housing or the dis-
charge chute. Any contact with the
moving parts will cause serious injury.
Stop the engine and remove the spark
plug wire from the spark plug and use a
long (at least 3-feet [100CM] long)
wooden stick to unclog these areas.
WARNING
Figure 4-5
Figure 4-4
As you turn, rotate the
discharge chute so that
the snow is always
thrown in this direction.
The discharge chute stays the same direction
except when turning. Snow is thrown to each side.
➡
15