Filter
Top Products
6F3B0253
Basic Hardware and Function 83
6. Programming Information
Device/
register
Name Function
SW07 Clock/calendar (Year) Lower 2 digits of the calendar year
(01, 02, ... )
SW08 Clock/calendar (Month) Month (01, 02, ... 12) They are stored in
SW09 Clock/calendar (Day) Day (01, 02, ... 31) the lower 8 bits by
SW10 Clock/calendar (Hour) Hour (00, 01, ... 59) BCD code
SW11 Clock/calendar (Minute) Minute (00, 01, ... 59)
SW12 Clock/calendar (Second) Second (00, 01, ... 59)
SW13 Clock/calendar (Week) Day of the week
(Sun = 00, Mon = 01, ... Sat = 06)
SW14
−
Reserved
SW15 Peripheral support priority Bit 8 (S158) is used to select peripheral support priority
SW16 Mode of special input
functions
Used to select the special input functions
SW17 Input filter constant Used to set the input filter constant
SW18 Preset values for high Used to set the preset values for high speed counters
SW19 speed counter
SW20
SW21
SW22 Count values for high Present count values of the high speed counters are
SW23 speed counter stored
SW24 High speed counter control
flags
Control flags for the high speed counters
SW25
−
Reserved
SW26 Mode of special output
functions
Used to select the special output functions
SW27 Special output control flags Control flags for the pulse/PWM output
SW28 Special output frequency
setting
Output frequency setting for the pulse/PWM output
SW29 PWM output duty setting Pulse duty setting for the PWM output
SW30 Analog setting value 1 Input value of the analog setting adjuster V0
SW31 Analog setting value 2 Input value of the analog setting adjuster V1
SW32
−
Reserved
SW33
−
Reserved
SW34 TL-F10 send data TOSLINE-F10 transmission data (send to master)
SW35 TL-F10 receive data TOSLINE-F10 transmission data (receive from master)
SW36 PRG port station address Used to set the programmer port station address
(1 to 32)
SW37 PRG port parity Used to set the programmer port parity (0=none,
1=odd)
SW38 PRG port response delay Used to set the programmer port response delay time
(0 to 30: 0 to 300ms)
(1) These devices are set by the T1-16S operating system. These devices
are read only for user.
(2) Devices marked as (down) are set in the ERROR mode. Therefore
these devices cannot be used in the user program.
NOTE