Filter
Top Products
25
SECTION 11: OFF-SEASON STORAGE
WARNING: Never store the machine or fuel
container indoors where there is an open
flame, spark or pilot light such as on water
heater, furnace, clothes dryer or other gas
appliance.
WARNING: Use a fuel stabilizer additive or
drain the fuel into an approved container
outdoors, away from an open flame. Allow
engine to cool. Extinguish cigarettes, cigars,
pipes and other sources of ignition prior to
draining fuel.
If the machine is to be inoperative for a period longer
than 30 days, prepare for storage as follows.
• Clean the engine and the entire unit thoroughly.
• Lubricate all lubrication points. Wipe the entire
machine with an oiled rag to protect the painted
metal surfaces.
• Refer to the engine manual for correct engine
storage instructions. The engine must be completely
drained of fuel to prevent gum deposits from forming
on essential carburetor parts, fuel lines and fuel
tanks.It is not necessary to remove the battery from
the tractor for storage. However, clean the top of the
battery and make sure it has full charge. Disconnect
the negative terminal of the battery before storing
the tractor.
• Store unit in a clean, dry area.
NOTE: When storing any type of power equipment in
an unventilated or metal storage shed, care should be
taken to rustproof the equipment. Using a light oil or
silicone, coat the equipment, especially any chains,
springs, bearings and cables.
NOTE: Recharge the battery before returning it to
service after storage. Even if the tractors starts, the
engine charging system may not bring the battery upto a
full charge, unless it is recharged.
SECTION 12: MAINTENANCE CHART
* Toro reserves the right to change product specifications, design, and standard equipment without notice and without incurring obligation
** Kohler’s horsepower ratings exceed Society of Automotive Engineers Small Engine Test Code J1940. Actual engine horsepower is lower and
affected by, but not limited to, accessories (air cleaner, exhaust, charging, cooling, fuel pump, etc.), application, engine speed and ambient
operating conditions (temperature, humidity, and altitude).
Before
Each Use
After Initial
24 Hours
Every
10 Hours
Every
25 Hours
Every
50 Hours
Every
Season
Prior
to Storing
Clean Hood/Dash Louvers
Check Engine Oil Level
Clean and Re-oil Air
Filter’s Foam Precleaner
Replace Air Filter Element
Change Engine Oil & Filter
Clean Battery Terminals
Lube Front Axles and Rims
Clean Engine Cooling Fins
Lube Pedal Pivot Points
Lube Deck Spindles
Check Spark Plugs
Check Safety Interlock
System