Filter
Top Products
Special Tools
NOTE: Order special tools from the
TORO SPECIAL
TOOLS AND APPLICATIONS GUIDE (COMMERCIAL
PRODUCTS)
. Some tools may be listed in the
HydroJect 3000 Parts Catalog. Some tools may also be
available from a local supplier.
Hydraulic Tester - With Pressure and Flow Capabilities (Fig. 9)
Flow Meter
Gauge
Gauge
Gauge
Load Valve
Outlet
Hose
High Pressure
Inlet Hose
Protector Valve
Low Pressure
Figure 9
You must have o-ring face seal (ORFS) adapter fittings
for this tester to use it on the HydroJect 3000.
1. INLET HOSE: Hose connected from the system
circuit to the inlet side of the hydraulic tester.
2. LOAD VALVE: If required, upon turning the valve to
restrict flow, a simulated working load is created in the
circuit.
3. LOW PRESSURE GAUGE: Low range gauge to
provide accurate reading at low pressure, 0 - 1000 psi.
This gauge has a protector valve which cuts out
when pressure is about to exceed the normal range
for the gauge. The cutout pressure is adjustable.
4. HIGH PRESSURE GAUGE: High range gauge to
accommodate pressure beyond the capacity of the low
pressure gauge, 0 - 5000.
5. FLOW METER: This meter measures actual oil flow
in the operation circuit, with a gauge rated at 15 GPM.
6. OUTLET HOSE: Hose from the outlet side of the
hydraulic tester to be connected to the hydraulic system
circuit.
HydroJect
™
3000 Page 4 - 7 Special Tools