Filter
Top Products
Lubrication
The Hydroject 3000 has 5 grease fittings that must be
lubricated every 50 hours of operation with No. 2 Gener
-
al Purpose Lithium Base Grease. Lubricate all fittings
immediately after every washing, regardless of interval
listed.
The bearings and bushings that must be Iubricated are
the steering pivot shaft (Fig. 1), limit switch housing (2)
on lift arm shaft (Fig. 2) and neutral pivot shaft (Fig. 3).
1. Wipe grease fitting clean so foreign matter cannot
be forced into the bearing or bushing.
2. Pump grease into the bearing or bushing.
3. Wipe up excess grease.
Figure 1
Figure 2
Figure 3
Product Records and Maintenance
Page 2 – 4
Rev. B
Hydroject 3000