Filter
Top Products
Two Stage Snowthrower Drive Systems Manual 1 - 5
Auger Gearbox Service
5. There are 4 locknuts in the forward part of the
housing. These are on studs from the auger.
Remove the locknuts. The traction assembly will
now lift straight up off the auger assembly
(Figure 15).
Figure 15
2768-025
6. Now perform steps 1 - 9 under “GEARBOX
REMOVAL” on page 1 - 1.
Secondary Method — Traction and Auger
Housings Separated: All Other Models
1. Remove the belt cover, loosen the belt guide, and
remove the traction belt (Figure 16).
Figure 16
MVC-526
2. Disconnect the chute crank rod at the auger
(Figure 17).
Figure 17
MVC-534
3. Place a block of wood under BOTH the auger and
traction assembly to support them when the
connecting cap screws are removed. Remove the
6 cap screws, 3 on each side, that connect the
auger to the traction assembly and separate the
two (Figure 18).
Figure 18
MVC-535
4. Now perform steps 1 - 8 under “GEARBOX
REMOVAL” on page 1 - 1.
1
1
.
L
oc
k
nu
t