Filter
Top Products
Auger Gearbox Service
1 - 4 Two Stage Snowthrower Drive Systems Manual
9. The auger flighting is attached to the auger shaft
with one bolt and locknut. Reach through the
holes in the drum augers to access. On models
without drum augers, the bolts are easily
accessible (Figure 11).
Figure 11
MVC-533
The auger assembly can be separated from the
traction assembly. However, it is generally not
necessary to work on the auger. Should the auger
pulley be rusted on the shaft, it might be easier to
remove the pulley with the traction assembly out of the
way.
Secondary Method — Traction and Auger
Housings Separated: Toro Models 38065
and 38080
1. Remove the belt cover. Loosen the belt guide and
remove the auger belt (Figure 12).
Figure 12
2768-021
2. Drain the fuel and oil and stand the machine up on
its auger. Support or brace to prevent tipping
(Figure 13).
Figure 13
2768-027
3. Disconnect the chute crank rod at the auger
(Figure 14).
Figure 14
MVC-534
4. Remove the lower cover from the traction
assembly.
1
1
.
A
ccess
h
o
l
e