Filter
Top Products
Maintenance Section 4-14
MAINTENANCE
ADJUSTING THE CABLE LIFT
Extend the outboard cylinder until the mower deck touches its stop on the draft
beam as shown. NOTE: Make sure the cable turnbuckle is loose enough to allow
the cylinder to reach full extension before the head reaches the stop. Now hold the
head against the stop and tighten the turnbuckle until the cable is tight. Lower and
raise the head to check the adjustment. The head should touch its stop at the same
time the cylinder reaches full extension. Tighten turnbuckle lock nuts securely after
adjustment is complete.
GREASING THE CASTER WHEEL SWIVEL
Locate the grease zerk on the caster wheel swivel boss as shown. Inject
Lithium-Complex Extreme Pressure grease conforming to NLGI2-ISO 320
specifications into the boss until the grease protrudes from the ends. Grease
daily or every 8 hours of service.