Filter
Top Products
Assembly Section 2-15
ASSEMBLY
FILLING HYDRAULIC RESERVOIR
Refer to the maintenance section for filling specifications and hydraulic oil
requirements.
NOTE: Starting or running your Tiger mower before filling reservoir will
cause serious damage to hydraulic pump.
MOTOR SOLENOID VALVE MOUNTING
Install a motor solenoid valve to the bracket on main frame with the capscrews,
star lockwasher flatwasher, lockwashers and hex nuts as shown in the parts section.
Be sure that the pump and tank oil ports are pointing down. Be sure that the star and
regular lockwashers are not on the same capscrew. Ground one of the red solenoid
wires to the mounting bolts with the star lockwasher at this time.
ADJUSTING REAR WHEELS
Follow the instructions in the tractor owners manual for adjusting tires
and rims. The rear wheels MUST be adjusted to the widest setting. NOTE: This
may require switching the wheels to opposite sides of the tractor. Also take note of
any width restrictions when transporting by trailer. (For ease of installation, it is best
to leave rear wheels removed during installation of the mower).
3-POINT DECK TILT CYLINDER
Remove the support cylinder from the left rear three point arm and replace with the
cylinder, clevis ends, and pin furnished in the kit. See part section for parts and assembly.