Filter
Top Products
Assembly Section 2-16
ASSEMBLY
DRAFT BEAM MOUNTING
Pull the inboard cylinder piston rod down to the extreme extended position. Slide
the draft beam under the cylinder, and align clevis hole with draft beam hole nearest
to the tractor. Install pin and secure with R-clips.
Using inboard cylinder as a pivot point, slide draft beam under tractor and
install draft beam pin. Align hole in draft beam pin with holes in main frame boss
and install cap-screw, lock-washer and hex nut.
Install the fittings in the butt end of the outboard cylinder, as shown in the
commons section. These should be positioned to face the rod end of the
cylinder. Next, install the O-ring breather in the rod end of the cylinder.
Install the outboard cylinder in the hole in the draft beam as shown above.
Install the pin into the draft beam and cylinder and secure with R-clips.
CABLE LIFT DRAFT BEAM INSTALLATION
Install ½” O-ring breather into butt port of inboard cylinder. Install fittings in the
rod end of the cylinder according to the diagram in the commons section. These
fittings should be positioned to face the butt end of the cylinder.
Next turn the clevis onto the rod of the cylinder until it is tight against the
shoulder and lock into place with locking bolt on clevis.
The inboard cylinder can now be installed into the main frame mast with the
pin, flat-washers and R-clips as shown below. Use teflon tape on all fitting and
hose connections.