Filter
Top Products
Assembly Section 2-7
ASSEMBLY
PRESSURE LINE INSTALLATION
The hydraulic pressure line will be plumbed into the rear of the tractor remote
valve end cap. Locate the pressure port and remove the plug (refer to the illustration
below and the Parts Section pages for position of the pressure port). After the plug is
removed then install 22mm adapter. Next connect a 1/2”FJX x 1/2”FJX 90 hose from
the tractor remote valve to the Tiger valve.
RETURN LINE INSTALLATION
The return line will be plumed in next to the pressure line in the tractor remote
valve end cap. Locate the return port and remove the plug (refer to the illustration
below and the Parts Section for the position of the return port). After the plug is
removed then install 22mm adapter. Next connect a 1/2”FJX x 1/2”FJX 90 hose from
the tractor remote valve to the Tiger valve.
ORIGINAL END CAP