Filter
Top Products
Operating Basics
AFG3000 Series Quick Start User Manual
57
Add Signal (AFG3100 and AFG3200 Series)
The AFG3101/AFG3102 and AFG3251/AFG3252 rear panel ADD INPUT connector allows you to add an external signal
to the CH1 output signal.
Quick Tip
■ The Output Status (see page 24) is changed from Output Off to Ext Add when you push the front-panel CH1 Output
button to enable the output.
1. Connect an external signal source to
the rear panel ADD INPUT connector.
2. Push the front-panel Top Menu
button, and then push the Output
Menu bezel button.
3. Push External Add to select On.
4. The following is an example of adding
noise as an external signal. The upper
waveform is an external signal.
5. The bottom waveform is a square
waveform before adding external sig-
nal.
6. This is an example of square waveform
after adding external signal (noise).
120
VA
1
3
2
4
5
6