Filter
Top Products
RCC130H-CRACK SAW OPERATION AND PARTS MANUAL REV #1 (11/18/04) PAGE 35
MAINTENANCE/SERVICE
FIGURE 40
FIGURE 41
CAUTION
Exercise extreme caution when pressing the hub
body from the arbor shaft/bearing block
assembly. Improper activities can result in the
components striking body parts, resulting in
property damage and/or personal injury.
8) Position the arbor shaft assembly in a suitable
arbor press with the snap ring shoulder facing down.
Determine that the bearing block face is properly
supported. The outside diameter of the bearing must
be clear for axial movement. Press the arbor shaft
assembly from the bearing block. FIGURE 42.
Reposition the assembly and press the remaining
bearing from the bearing block. FIGURE 43.
FIGURE 42
FIGURE 43
9) Clean and inspect the arbor shaft and bearing
block for wear and damage. Replace any
questionable component with a factory replacement
part only.
10) Clean the outside bore diameter of the
replacement bearing with an appropriate solvent.
Apply a suitable amount of anaerobic
adhesive/sealant to the outside diameter of the
bearing. Determine that the outside diameter of the
bearing will absorb the thrust from the pressing
process. The inside bore of the bearing should not
receive any direct thrust force. Press the
replacement bearing into the bearing block until it
seats itself against the flange.