Filter
Top Products
STOW CUTTER 3 CE SAW — PARTS & OPERATION MANUAL — REV. #5 (09/22/06) — PAGE 35
STOW CUTTER 3 CE SAW — SHUT-DOWN PROCEDURES
Stopping the Engine (Self-Propelled Models)
Figure 45. Throttle Lever
Figure 47. Engine ON/Off Switch ( engine)
Figure 48. Fuel Valve Lever (Off Position)
Figure 50. Throttle Lever (Slow Position)
Figure 51. Ignition Switch (OFF Position)
Figure 46. Engine Shutdown Switch (handlebars)
2.
Turn the engine Shutdown switch located on the handle-
bars (Figure 46) to the "OFF" position. Shutting the engine
off using this switch confirms that is is functioning properly.
4. Place the fuel valve lever (Figure 48) to the OFF position.
3. Turn the
engine ON/OFF switch
(Figure 47) to the "OFF"
position.
1. Place the
engine throttle lever
(Figure 45) in the SLOW
position, and listen for the engine speed to decrease. Allow
engine to run for 2 or 3 minutes for proper cooldown.
Stopping the Engine (Push Model)
Stopping the engine under normal conditions:
Figure 49. Speed Lever (Neutral Position)
Stopping the engine under normal conditions:
1. Disengage the drive by placing the
forward/reverse speed
lever
(Figure 49) in the NEUTRAL position.
3. Turn the engine Shutdown switch located on the handle-
bars (Figure 46) to the "OFF" position. Shutting the engine
off using this switch confirms that is is functioning properly.
2. Place the
engine throttle lever
(Figure 45 or Figure 50) in
the SLOW position, and listen for the engine speed to
decrease. Allow engine to run for 2 or 3 minutes for proper
cooldown.
4. Turn the
engine ON/OFF switch
(Figure 47 or Figure 51) to
the "OFF" position. The Ignition Switch on Electric-Start
models must be turned off to prevent unwanted battery
discharge.
5. Place the fuel valve lever (Figure 48) to the OFF position.
OR