Filter
Top Products
STOW CUTTER 3 CE SAW — PARTS & OPERATION MANUAL — REV. #5 (09/22/06) — PAGE 27
9. Place the
throttle lever
(Figure 28) halfway between FAST
and SLOW for starting.
All sawing is done at full throttle. The
engine governor speed is factory set to ensure optimum
blade operating speeds.
The engine governor speed has been set at the factory.
Changing the governor speed could damage the blade and/
or the saw.
CAUTICAUTI
CAUTICAUTI
CAUTION
STOW CUTTER 3 CE SAW — MANUAL START-UP (13HP HONDA ENGINE)
Figure 26. Choke Lever (Open Position)
7. If operating the Cutter 3 CE in
cold weather conditions
,
skip this step and proceed to step 8. Place the
Choke Lever
(Figure 26) in the OPEN position. Skip to step9.
The CLOSED position of the choke
lever enriches the fuel mixture for
starting a COLD engine. The OPEN
position provides the correct fuel
mixture for normal operation after
starting, and for restarting a warm
engine.
NOTE
8. If operating the Cutter 3 CE in
cold weather conditions
,
place the
Choke Lever
(Figure 27) in the CLOSED position.
Figure 27. Choke Lever (Closed Position)
Figure 25. Fuel Valve Lever
6. Place the
Engine
ON
/
OFF
switches
(Figures 23 and 24) to
the ON position.
3. Ensure the diamond blade has been mounted correctly and
that it is raised above the surface you are about to saw.
4. Ensure the water tank is filled to capacity (18.95 liters/5
gallons). Connect the water tank hose to the water system
brass fitting on the rear of the console (Figure 18) and test for
adequate water flow to the diamond blade before operation.
When ready to start cutting, turn the water on.
5. Place the
fuel valve lever
(Figure 25) to the ON position.
Figure 24. Engine ON/Off Switch (Engine)