Filter
Top Products
PAGE 26 — STOW CUTTER 3 CE SAW — PARTS & OPERATION MANUAL — REV. #5 (09/22/06)
STOW CUTTER 3 CE SAW — MANUAL START-UP (13HP HONDA ENGINE)
The following start-up procedure makes reference to a HONDA
13 HP Engine (Manual Start).
NEVER place hands or feet inside the belt
guard or blade guard while the engine is
running. ALWAYS shut the engine down
before performing any kind of
maintenance service on the saw.
Keep Wheel Clamp applied (lever DOWN)until
completely ready for cutting operation.
Figure 22. Wheel Clamp
D
CAUTICAUTI
CAUTICAUTI
CAUTION
D
WARNINGWARNING
WARNINGWARNING
WARNING
D
CAUTICAUTI
CAUTICAUTI
CAUTION
DO NOT attempt to operate the saw until
this manual has been read and thoroughly
understood. Engine operating steps may
vary. See included engine manufacturer's
operating manual.
Ensure the work area is clear of tool, debris, and
unauthorized people.
D
CAUTICAUTI
CAUTICAUTI
CAUTION
1. Ensure the wheel clamps are in the LOCKED position.
(Figure 22).
Figure 23. Engine Shutdown Switch (Handlebar)
NOTE
The Engine Stop Switch located on
the handlebar (Figure 23) serves
both as an Emergency Engine
Shut-Off and as the primary
Shutdown switch. This allows the
operator to shutdown the saw safely
away from moving parts.
When the engine is running the cutting
blade is ALWAYS
rotating
. Keep
hands and feet clear of rotating blade.
Raise the saw to full height when
maneuvering the saw within the cutting
area.
All displacement of the machine
outside the cutting area shall be carried
out with the tool not in rotation.
WARNINGWARNING
WARNINGWARNING
WARNING
2. Ensure the engine Shutdown switch on the handlebar and
the engine ON/OFF switch on the engine are both in the
OFF position to avoid accidental starting. (Figures 23 and
24)
NOTE
After shutdown on Electric Start
models, ensure the Engine Start
switch is turned to the OFF position
to avoid battery discharge and
accidental starting.
MANUAL START-UP (13HP HONDA ENGINE)