Filter
Top Products
7
Section 2 - OPERATING INSTRUCTIONS
2.1 PRE-START CHECK LIST
Make the following checks and perform the service
required before each start-up.
2.1.1. Check guards, deflectors, grass bag, adapter
and covers to make sure all are in place and securely
tightened.
2.1.2. Check blade control, wheel drive control, and
ground speed control to insure they work freely. See
Figure 2.1.
2.1.3. Check cutting height. Adjust to desired height.
Refer to Section ‘Cutting Height Adjustment’.
2.1.4. Check engine oil and add oil as needed to bring
level up to the full mark. Refer to Engine Owner’s
Manual for oil specifications. See Figure 2.2.
2.1.5. Add fuel to tank after pushing the mower outside
where fumes can safely dissipate. Make sure cap is
tightened after refueling. Refer to Engine Owners
Manual for specifications.
2.1.6. Clean exterior surfaces of cutting deck and
engine of any accumulation of spilled fuel, dirt, grass,
oil, etc. Keep engine air intake screen and cooling fins
clear at all times.
2.2 STARTING & OPERATION
2.2.1. ENGINE & BLADE
1. Push primer button three times to start a cold
engine. See Figure 2.3. NOTE: The primer should not
be required to restart a warm engine.
2. Pull blade control against handle. See Figure 2.4.
3. Start Mower:
Manual Start Models: Pull rope start handle to crank
engine. See Figure 2.4.
Electric Start Models: Insert key into ignition switch,
located on right side of handle above rope guide. Turn
key to crank engine. See Figure 2.5.
4. After engine starts, allow a brief warm-up until
engine runs smooth before beginning mower opera-
tion.
NOTE: To stop the engine (and blade), release the blade
control.
BLADE
CONTROL
FIGURE 2.1
FIGURE 2.2
FIGURE 2.3
PRIMER
BUTTON
(PUSH 3X)
GROUND SPEED
CONTROL
WHEEL DRIVE
CONTROL
SQUEEZE
BLADE
CONTROL
FIGURE 2.4
PULL ROPE
START
HANDLE
START
FIGURE 2.5
RUN