Filter
Top Products
12
Section 3 - MAINTENANCE
3.3.4. Wheel Drive Components
1. Remove rear cover. Refer to Section “Rear Cover
Removal & Installation”.
2. Clean debris buildup on or around transmission,
axles, idler, pulleys, belt, etc., as well as on underside
of cover. Check components for wear or damage.
Replace worn or damaged components immediately.
3. Replace rear cover.
IMPORTANT: DO NOT operate mower without rear cover
securely in place.
3.4 STORAGE PROCEDURE
Refer to the Engine Owner’s Manual for directions regard-
ing engine storage preparations. Prepare the mower for
“end of season” storage as follows:
1. Drain fuel from fuel tank and let engine run until all
fuel is out of the carburetor.
2. Disconnect and remove the spark plug wire away
from spark plug before any other preparations are
made!
3. Tape all openings closed to prevent spraying water
into exhaust or air intakes during washing.
4. Tilt mower up on its rear wheels and thoroughly
clean the underside of the deck. Do not tilt mower with
spark plug or carburetor down. Scrape away any accu-
mulation of grass with a putty knife and or wire brush.
5. Lubricate all exposed metal with a light coating of
oil to prevent corrosion.
6. On self-propelled models, move ground speed con-
trol back to slow (‘turtle’) position to prevent stretching
of belt and/or idler spring.
7. Carefully fold the handles, “flexing” the control
cables to prevent cable damage.
8. Store the mower in a shed or other dry area, pro-
tected from weather.
WARNING
DO NOT attempt any maintenance, adjustments or
service with engine and blade running. STOP engine
and blade. Disconnect spark plug wire and secure away
from spark plug. Engine and components are HOT.
Avoid serious burns, allow sufficient time for all
components to cool. Wear heavy leather gloves when
handling or working around cutting blades. Blades are
extremely sharp and can cause severe injury.
!
!