Filter
Top Products
Normal Removal
13
A. Channel Assembly H. Lower Chute
B. Cover I. Pin
C. Pin J. Middle & Upper Tube
D. Hitch K. Strap, Middle
E. Bag L. Ridge
F. White Bar M. Ridge Cutout
G. Tubes
E
L
D
B
Figure 23. Normal Installation & Removal (38” Free Floating Mower Shown)
C
I
H
M
A
G
Collector Removal
1. Unhook strap (K, Figure 23) from pin (I). Remove
middle and upper tube (J) from cover (B).
2. Lift up cover (B) remove and empty bags (E).
3. Remove pin (C). Lift and remove channel assembly
(A) and cover (B) from hitch (D).
WARNING
OPERATION WITHOUT BAGGER
For operation without bagger, the mower
deflector MUST be properly installed in the down
position and retained by the spring latch.
F
K
38” Free Floating Mowers
4. Lift discharge deflector up (E, Figure 21).
5. Loosen wing nut (B).
6. Slide lower chute (A) off carriage bolt (D) and
deflector hinge rod (F).
42” and 38” Frame Hung Mowers
4. Lift discharge deflector up (E, Figure 22).
5. Remove wing nut (D) from carriage bolt (F).
6. Remove the knob (B) from carriage bolt (C).
7. Remove the lower chute (A) from carriage bolt (F).
8. Remove lower chute (A) from carriage bolt (C).
J