Filter
Top Products
Initial Tube Installation
10
A
F
B
Figure 17. Install Lower Discharge Chute 38” Free
Floating Mowers
A. Lower Chute
B. Wing Nut
C. Rubber Strap
D. Carriage Bolt
E. Discharge Deflector
F. Deflector Hinge Rod
G. Bracket
LOWER DISCHARGE CHUTE INSTALLATION (38” FREE
FLOATING MOWERS)
1. Lift discharge deflector up (D, Figure 17).
2. Slide the notch of bracket (G) on to deflector hinge
rod (F).
3. Secure the front of lower chute (A) to carriage bolt
(D) using wing nut (B).
Note: Locknut (C) is intended to keep wing nut (B)
permanently on carriage bolt (D).
LOWER DISCHARGE CHUTE INSTALLATION (42” AND 38”
FRAME HUNG MOWERS)
1. Lift discharge deflector up (E, Figure 18).
2. Place the front hole of the lower chute (A) onto
carriage bolt (C) as shown. Slide front edge of lower
chute (A) under hinge bracket (G).
3. Place the rear hole of the lower chute (A) onto
carriage bolt (F) as shown.
4. Secure knob (B) onto carriage bolt (C) as shown.
5. Secure wing nut (D) onto carriage bolt (F) as shown.
C
E
D
A
B
Figure 18. Install Lower Discharge Chute 38” Free
Floating Mowers
A. Lower Chute
B. Knob, 5/16-18
C. Front Carriage Bolt, 5/16-18 x 3/4
D. Wing Nut, 5/16
E. Discharge Deflector
F. Rear Carriage Bolt, 5/16-18 x 3/4
G. Hinge Bracket
D
C
E
G
F
G